Jerri Dunn Floor Lamp November 14th, 2018 - 05:09:52
The lamp off the head of the spoon to make the lower part of the map. I think I ended up using all three boxes of spoons for this project start gluing the pieces you broke off to the base of the narrow when placing the secular glue, the spoons in between the spoons of the first layer to create the floured. Look repeat the same process for all the layers here I measured eight inches in between the layers, but I later decided to do five inches instead, because I didn't like the huge gaps between the layers. Making these top layers is a bit tough and time-consuming because you have to hold each spoon until it dries before gluing its neighbor.
Now that you have everything glued, let it sit for about 30 minutes or so spray. The lamp with the primer, the primer, helps the gold spray paint hold better and not chip off the paste, wear a protective mask of some sort and make sure you do this in a well-ventilated area and let the primer dry for about an hour. So before spraying, the gold paint, give the paint a couple of days to dry completely before using it.
I cut this small circle out using a hole saw and now I'm putting a 3/4 inch hole in the center of it and I'm drilling three holes through the edges of this, I'm going to glue this thing to the underside of the table and finally, I can glue the legs up. This is half-inch steel, a conduit that I'm spray-painting silver. I'm going to finish this with a few coats of brushing lacquer. These three screws will tighten down that hole and also lets me level it back and forth a little bit make sure it's straight.
Copyright © 2019 rmhnashville.com. Reproduction without explicit permission is prohibited. All Rights Reserved.
User Agreement, Privacy, Cookies. Wall clock white bathroom vanity solar string lights best soap dispenser best toilet seat oak rocking chair square tablecloth bathroom sinks plastic tablecloth outdoor light accent chair.